Junctions¶
A junction is a seam that follows the intersection of two meshes: weld lines, thin gaps, or any decal pattern running along where two objects meet. It stays live while you move the objects.
How to add a junction¶
- In Object Mode, select the two intersecting meshes. Make the one that should receive the decal the active object.
- In the Decal Workshop tab, click Add Junction.
- Set the look with the mouse (see below), then confirm.
The add-on creates an object named DW Junction with a Geometry Nodes modifier that follows the intersection. Your two meshes are left untouched.

Controls while adding¶
| Input | Action |
|---|---|
| Mouse move | Width (Shift for precision, Ctrl for 5 mm steps) |
| Wheel | Segments |
| Ctrl + wheel | Tiling |
| F | Flip between surface and seam |
| Hold O + mouse move | Surface Offset |
| Left click, Enter or Space | Confirm |
| Esc or right click | Restore the starting values (the junction stays) |
Junction Options¶
Select the junction object and click the options button next to Replace to open the settings box.
| Option | Default | Effect |
|---|---|---|
| Width | 0.03 m | Width of the seam |
| Surface Offset | 0.0005 | Gap above the surface |
| Resolution | 128 | Quality of the intersection curve |
| Width Segments | 4 | Subdivisions across the width |
| Tiling | 1.0 | Repetition of the pattern along the seam |
| Exact Solver | Off | More precise intersection (Blender 4.5 and newer). Turned on automatically when the meshes are open and the normal solver finds no intersection |
| Material | Material of the junction |

How to change the pattern: Replace¶
By default a junction uses the Thin Seam decal.
- Select the junction.
- In the Library, open the Junctions category and select another entry.
- Click
Replace.
The meshes and the intersection stay as they are. Only the pattern changes.
How to bake: Apply Junction¶
Apply Junction (in the options box) bakes the junction into a real mesh.
Apply is the only destructive step
After Apply Junction the junction is no longer live: you cannot change its width or pattern. Your source meshes stay intact.
Use it when you want a plain mesh, for example before export.
Tips¶
Meshes must intersect
A junction follows the line where the two meshes actually cross. If nothing happens, check that the objects intersect.
Undo friendly
Press Esc during the interactive step to restore the values you started with. The junction object stays, so delete it if you do not want it.